Help / FAQ
DIY Drones Website, you will find there an AWESOME community!
Did not received the latest newsletter? View it here!
CanadaDrones / Kildir
Flight Controller / Autopilot
DJI Flight controller
Battery, Chargers & Acc.
Cables & Connectors
Lights and Show
Motors, ESC, Props
R/C Plane Gear
Screws, spacers, nuts
Video / OSD
Tweets by @CanadaDrones
Proud sponsor of
Proud sponsor of
jD-IOBoard v1.1, MCU controlled IO Board for driving LEDs, Relays, Servos
Quantity in Stock:
(Out of Stock)
Usually Ships in 1 to 2 Business Days
Email me when Back-In-Stock
jD-IOBoard v1.1, Driver board for your needs
jD-IOBoard just got better. This is our new v1.1 board. So take a look at our document site to notice differences with older board.
If you need to drive LED strips, LEDs, Lamps, Relays or similar devices jD-IOBoard is the answer for your needs. This board is fully Arduino compatible board and it has 6 high power outputs and can handle all the way 42 Volts and 500mA / output pin.
Board have easy access to FTDI / UART and I2C ports. Among high power outputs there are several TTL level GPIO pins and Analog pins.
Atmega 328P MCU
ULN2003A darlington array for high power outputs
6 x TTL GPIO pins
6 x TTL Analog pins (only 4 if using I2C bus)
ISP pins for deep programming
Size: 37mm x 18mm
Assembly and usage documentation in
jDoc - jD-IOBoard
Source codes etc in
jD-IOBoard v1.0 demo
jD-IOBoard and MAVLink demo
Write a review »
0 of 0 people found the following review helpful:
August 25, 2013
Reviewer: Virgil Cartan from Gatineau, QC Canada
Excellent board ,you can do a lot of application and easy to program.
Was this review helpful to you?
Become an Affiliate
Daily pursuit of excellence